Presentation on theme: "Operation of the Chalk making machine Technology supported by Xuguan on Line"— Presentation transcript:
Operation of the Chalk making machine Technology supported by Xuguan on Line
Introduction of the machine The high efficiency chalk making machine made in our factory is a modern design synthesizing all advantages of chalk machines both in China and abroad. It is reasonable in structure and convenient for operation. It produces 1,000 pieces of chalk at one machine cycle.
How to make Chalk? ? The chalk making machine consists of four main parts, namely the chalk moulding box, the chalk stripping system, the frame of the ejecting mechanism and dumper
How about the machine!! 1. Moulds m ade of the seamless red copper tubes, the mould has high smooth, rustproof inner surface, which will have a very long servicing life. 2. Equip with hand bar, roller bearings, the ejecting mechanism can smoothly and nimbly operated. 3. For preventing the liquid chalk material and dust gong into the operating mechanism of the machine, the frame of the ejecting mechanism is wholely sealed. 4. The dumper is equip with center adjusted roller bearings, so it can be effortlessly and easily turned over.
Installation of the machine Before starting, the machine should be steadily placed on a hard surface. The mechanism should be seriously checked if there is any loose. At the meantime, clean the whole machine thoroughly and lubricate all the lubricating points. Operate with no load several times. The machine can be put into operation only in the condition that every part of it is in good order.
Operation-pouring 1. Take the mould box to the injecting position. 2. Apply few lubricating liquids (oil) on the mould. 3. Put the milky chalk material into the trough. Take out the surplus material before solidifying.
Turn the box!! After the material fully solidified, operate the hand bar by hand and turn the mould box to 180 O
Go On!!!!!!!! 180 O!!!!!!!!!!!!!!!! the chalk will draw down to the table from the moulds automatically;
To take the chalk!! If there were also have some chalk stay in the moulds, please turn the three united bars located on the bottom of the box ( you can see it when you turn the box for 180 O ) for a cycle, the spare chalks will draw down. Those are the chalks you wanted.
Finish !!!!!! Turn the box to the first position for the next injection.
Haa! Contact me!! Why not? It is a good thing for me to talk with you about chalk making, if you have any question or problem, please do not hesitate to contact me. Tel: