Presentation is loading. Please wait.

Presentation is loading. Please wait.

Title: Director Presenter’s Name: Simon Hsu Economy: Chinese Taipei

Similar presentations


Presentation on theme: "Title: Director Presenter’s Name: Simon Hsu Economy: Chinese Taipei"— Presentation transcript:

1 Title: Director Presenter’s Name: Simon Hsu Economy: Chinese Taipei
Chinese Taipei’s Progress Report on Regulation Harmonization Title: Director Presenter’s Name: Simon Hsu Economy: Chinese Taipei

2 Amendment/Revision based on ECE Regulations
New Technical Regulations Using ECE as a basis List of relevant ECE Regulations

3 Vehicle Safety Testing Regulation(1/9)
Periodical Review : Twice a year (1st half & 2nd half), 1st half of /10/12, 2012/11/07, 2012/11/29 and 2013/03/08 2nd half of 2012 –To be discussed in May of 2013 Review on corresponding ECE’s amendment/revision for existing regulation; the Traditional Provision is taken into consideration, as appropriate, to allow necessary lead time ECE-related Part of Technical Regulations Discussed in 1st half of 2012 (1/2) Technical Regulation ECE Version Summary 020.Specification for Motor Vehicle ECE R107 04 Amending requirements for escape hatches and gangway mannequin of articulated buses. 033/034. Installation of Lights ECE R48 04-S7 ECE R53 01-S13 Amending requirements for electrical connections of main-beam and AFS. 281. Tyre ECE R75 00-R2/C1 Amending the content of Table, just like ”Section width (mm)” revised into “Maximum overall width(mm)”. 322 Front Fog lamp ECE R19 04-S1 Adding requirements for objective luminous flux. 340. Front position lamps ECE R07 02-S19 ECE R50 00-S15 Amending intensity of light emitted and colour of light emitted. 350. Rear position lamps Amending requirements for intensity of light emitted.

4 Vehicle Safety Testing Regulation(2/9)
ECE-related Part of Technical Regulations Discussed in 1st half of 2012 (2/2) Technical Regulation ECE Version Summary 370. Stop lamps ECE R07 02-S19 Amending requirements for intensity of light emitted. 380. S3 stop lamps Amending requirements for intensity of light emitted. 390. End-outline marker lamps 422. Dynamic Braking ECE R13 11-S7 Amending requirements for brake failure and defect warning signal and braking test, performance of braking systems. 431. ABS Amending requirements for failure within the electric control transmission. 540. Prevention of fire risks for the large passenger vehicle ECE R107 04 Adding requirements for alarm system to detect a temperature in the engine compartment and in each compartment where a combustion heater is located. 561 EMC ECE R10 04-C1 Adding requirements for related definitions, testing for conducted disturbances on AC or DC power lines, testing for immunity of vehicles to surges conducted along AC and DC power lines and testing for conducted disturbances on Network and telecommunication access from vehicle . 591. AFS ECE R S1 Amending requirements for general specifications, illumination, stability of photometric performance of systems. 630. Construction of Low-Floor Bus Adding requirements for the vertical distance between the floor of the seating area and the adjacent gangway shall be not more than 250 mm.

5 Vehicle Safety Testing Regulation(3/9)
ECE-related Part of Technical Regulations Discussed in 2nd half of 2012 (1/2) Technical Regulation ECE Version Summary 034 Installation of Lights ECE R48 05-S1 Amending requirements for tell-tale of front position lamp and rear position lamp. 202. Retro-reflective markings ECE R S7 Amending the Table of Minimum values for the Coefficient o Retro-reflection R’. 252 Safety glasses ECE R43 01 Amending requirements for related definitions, points of impact, mechanical strength test, headform test and test of resistance to high temperature and so on. 290 Filament lamps ECE R37 03-R6/C1 ECE R99 00-S7 Adding filament light source(filament lamp)of definition. Amending requirements for starting, run-up and hot-restrike characteristics and electrical and photometric characteristics. 302 Gas-discharge Headlamps ECE R98 01-S2 ECE R S10 Amending requirements for test voltage(related gas discharge light source with ballast integrated with the light source). 340. Front position lamps ECE R07 02-S17 Amending requirements for interdependent lamp system. 370. Stop lamps

6 Vehicle Safety Testing Regulation(4/9)
ECE-related Part of Technical Regulations Discussed in 2nd half of 2012 (2/2) Technical Regulation ECE Version Summary 390. End-outline marker lamps ECE R07 02-S17 Amending requirements for interdependent lamp system. 451. The protection of the occupants in the event of a lateral collision ECE R95 03-S1 Amending “exposed conductive part” of definition. 461 The protection of the occupants in the event of a frontal collision ECE R94 02-S2 522 Headlamp (HID excluded) ECE R S10 Amending requirements for test voltage(related gas discharge light source with ballast integrated with the light source). 591 AFS ECE R S2 Amending Table: Passing beam photometric requirements. 640 Electric safety requirements for battery electric vehicles ECE R S1

7 Vehicle Safety Testing Regulation(5/9)
New Technical Regulations Using ECE as a basis Drafted in 2012 and 2013(1/2) ECE Title of Item Scope and proposed date of implementation Status Large vehicle Small vehicle Motorcycle 34 Fuel Tank 2014/1/1 --- 1. Announced by MOTC on 2012/9/26. 2.Metallic and plastic fuel tank shall comply with hydraulic test and overturn test, for M and N. 64 Tyre pressure monitoring system (TPMS) 2014/11/1 Announced by MOTC on 2012/11/5. 107 Specification of open-top single-decker and double-decker buses To be determined Expecting to announce by MOTC RE3 Acoustic vehicle alerting system 2015/1/1 Prepared for MOTC discussion

8 Vehicle Safety Testing Regulation(6/9)
Drafted in 2012 and 2013(2/2) ECE Title of Item Scope and proposed date of implementation Status Large vehicle Small vehicle Motorcycle 14 ISOFIX --- To be determined Under discussion 23 Manoeuvring lamps 2014/1/1 Prepared for MOTC discussion

9 Vehicle Safety Testing Regulation(7/9)
ECE for M2/M3/N2/N3/O3/O4 ECE for M1/N1/O1/O2 ECE for L1/L3 Total 2004 R36, 52 2 2006 R3, 6, 7, 16, 19, 23, 28, 30, 37, 43, 48, 54, 77, 91, 98, 99, 104 17 R3, 6, 7, 16, 19, 23, 28, 30, 37, 39, 43, 54, 77, 91, 98, 99, 104 R39, 53, 60, 74, 81, 98, 99 7 22 2007 R19, 28, 78 3 2008 R5, 13, 14, 17, 25, 31, 38, 39, 66, 79, 80, 112, 113 13 R5, 11, 12, 13, 13h, 14, 17, 25, 31, 38, 48, 79, 94, 95, 112, 113 16 2009 R3, 37, 50, 112, 113, 38 6 1 2011 R46, 10, 123, 55 4 R46, 10, 123 R10, 2013 R75 2014 R34, 100 R34, 64, 100 38Announced 39Announced 18 Announced 52

10 Vehicle Safety Testing Regulation(8/9)
Taiwan has scheduled a plan to implement 66 ECE Regulations in 3 stages: stage 1(2006),stage 2(2007~2008)and stage 3(2009~2013). However, 18 among those scheduled regulations were postponed. So currently, 48 among those scheduled regulaitons were announced. 4 more regulations were added(ECE R64,100, 107 and 123) by MOTC afterwards. Up to now, Taiwan has already implemented and/or announced 52 ECE Regulations. Announced Reg. by MOTC but not yet effective: 2 Postponed Reg. by MOTC: 18 Announced & effective Reg. by MOTC: 49

11 Vehicle Safety Testing Regulation(9/9)
Table 1: Original implemented ECE regulations of summary Implemented of Stage Vehicle Category (Stage 1) (Stage 2) (Stage 3) Total reg. 2006 2007 2008 2009 2013 Large Vehicle and its Component 19 reg. 12 reg. 4 reg. 38 reg. Small Vehicle and its Component 17 reg. 16 reg. 6 reg. 39 reg. Motorcycle and its Component 7 reg. 3 reg. 2 reg. 18 reg. Total 24 reg. 10 reg. The total number: 52 reg. Note:1.Part of Regulations suitable for many vehicle category. For instance: ”Head Restraint” is suitable for large and small vehicle, and Part of Regulations like “Sound level of audible warning device” is suitable for whole vehicle and component. So, the total number in above table 1 may be have a little bit difference. 2.Not including 18 Regulations postponed.


Download ppt "Title: Director Presenter’s Name: Simon Hsu Economy: Chinese Taipei"

Similar presentations


Ads by Google