Presentation is loading. Please wait.

Presentation is loading. Please wait.

Security Systems BU Communication Systems ST/SEU-CO 1 DCN SPCC PO CCE 08.12.2004 Central Control Unit (Com - ports) LBB3500/15 2 x 9-pin Sub-D connector.

Similar presentations


Presentation on theme: "Security Systems BU Communication Systems ST/SEU-CO 1 DCN SPCC PO CCE 08.12.2004 Central Control Unit (Com - ports) LBB3500/15 2 x 9-pin Sub-D connector."— Presentation transcript:

1 Security Systems BU Communication Systems ST/SEU-CO 1 DCN SPCC PO CCE Central Control Unit (Com - ports) LBB3500/15 2 x 9-pin Sub-D connector RS 232 for: Facilities factory testing (diagnostics) direct PC control camera control remote control (Open interface) applications for: - Mimic panel (Microphone control) - Voting panel - Attendance registration - Intercom - Message Distribution I&O Manual

2 Security Systems BU Communication Systems ST/SEU-CO 2 DCN SPCC PO CCE Central Control Unit (Com - ports) LBB3500/15 Open interface applications for remote controller The DCN system provides a facility for controlling microphones, microphone management modes, attendance registration and voting from a remote controller. The remote controller can be custom built for a given application to control microphone activity - for example a push- button panel, with on/ off push- buttons and indicator. LEDs assigned to each microphone position can be used to control delegates microphones from a remote position. The communication protocol is message based binary interface (i. e remote functions and update information). Note:Before third parties can use the remote interface, the interface must be enabled on the CCU by installing the LBB3587 key-disk. - Only possible by using the LBB 3500/15 or /35

3 Security Systems BU Communication Systems ST/SEU-CO 3 DCN SPCC PO CCE CCU Trunk Communication Board (TCB-4) Key to symbols : 1 Jumper X14 (See Chapter (Table 4.4)) 2 S14 DIP- switches (See Chapter 4.6 ) 3 S10 Push- button switch to reset the Central Control Unit during servicing. 4 Three LEDs (left to right) green/ yellow/ red. Normally the green/ yellow LEDs flash in sequence, indicating the software is running. Red LED illuminates during system reset. 5 S9 DIP- switches (See Chapter (Table 4.3)) 6 Yellow LED indicates Digital Signal Processing (DSP) software is running. 7 Connector for multi- trunk board (used only in the multi- CCU) 8 Sockets for inserting flash EPROM (even) 9 Sockets for inserting flash EPROM (odd)

4 Security Systems BU Communication Systems ST/SEU-CO 4 DCN SPCC PO CCE CCU Trunk Communication Board (TCB-4) Key to symbols : 10 SRAM back- up battery 3.6 V (life- time 5 years min.) 11 Jumper X13 (See Chapter (Tables 4.4)) 12 Fuse 3.15 amp (delayed) 13 Connector for multi- trunk board (used only in the multi- CCU) 14 Serial RS232 Port 1 15 Serial RS232 Port 2

5 Security Systems BU Communication Systems ST/SEU-CO 5 DCN SPCC PO CCE Central Control Unit (Com - ports) LBB3500/15 LBB 3500/ 15 and LBB 3500/ 35 (TCB 4) Port 1 : DCN Control PC Port 2 : Camera Control In a single (stand- alone) CCU system two serial COM- ports (Port 1 and Port 2) are available. Both ports can be individually configured. NOTE: It is possible to select Full protocol on both Port 1 and Port 2. However this is NOT recommended due to processing power and memory limitations. Default settings are; 8 data bits No parity check 1 Stop bit

6 Security Systems BU Communication Systems ST/SEU-CO 6 DCN SPCC PO CCE TCB-4 DIP Switch Settings (default)

7 Security Systems BU Communication Systems ST/SEU-CO 7 DCN SPCC PO CCE Central Control Unit (Audio I/O) LBB3500/15 1. Asymmetrical Recorder In- & Outputs 2. 2 Asymmetrical line input connectors 3. Symmetrical or 2 Asymmetrical line outputs 1 3 2

8 Security Systems BU Communication Systems ST/SEU-CO 8 DCN SPCC PO CCE Central Control Unit (Audio I/O) LBB3500/15 1. Tape/cassette recorder input and output (Cinch-type) Tape In Asym.nom. -33 dBVmax. -3 dBV Tape Out Asym. nom. -33 dBV max. -3 dBV 2. 2 Asymmetrical line input connectors (Cinch-type) Line In Asym.nom. -18 dBVmax. +12 dBV 3. Symmetrical/Asymmetrical line output connectors (Cinch-type) Line Out Sym.nom. -12 dBVmax. +18 dBV Line Out Asymnom. -18 dBVmax. +12 dBV

9 Security Systems BU Communication Systems ST/SEU-CO 9 DCN SPCC PO CCE Central Control Unit (Trunk Outlets) LBB3500/15 1. Red LED overload indicators 2. Trunk outlet used for loop-through of the trunk-line-cable 1 2 Trunk

10 Security Systems BU Communication Systems ST/SEU-CO 10 DCN SPCC PO CCE Central Control Unit (Trunk Outlets) LBB3500/15 Trunk outlets For loop-through of the DCN trunk-line without regenerating the digital signal. Power handling capacity maximum: - 60 PCF per outlet PCF total for the three outlets of the CCU. PCF=<60 max.

11 Security Systems BU Communication Systems ST/SEU-CO 11 DCN SPCC PO CCE Mains socket with built-in fuse Nominal Mains voltage Mains fuse Power Consumption 220, 230, 240 V AC. T- 4A (slow blow)350 W 105, 115 V, 125 V AC. T- 5A (slow blow) Warning: All units must be powered via an earthed mains outlet. 115V-T4A/230V-T2A Extension Power Supply LBB4106/x0 I&O Manual

12 Security Systems BU Communication Systems ST/SEU-CO 12 DCN SPCC PO CCE Central Control Equipment End of section Robert Bosch GmbH All rights are reserved. Reproduction or passing on to third parties in whole or in parts is prohibited without the written consent of the copyright owner.


Download ppt "Security Systems BU Communication Systems ST/SEU-CO 1 DCN SPCC PO CCE 08.12.2004 Central Control Unit (Com - ports) LBB3500/15 2 x 9-pin Sub-D connector."

Similar presentations


Ads by Google