Presentation on theme: "Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user."— Presentation transcript:
Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user manual of DAS M32/M44] Fiber Optic www.dasdvbt.com
DAS ® 1.To install the DAS ® receiver, refer to the specific user manual; Pay attention on the connection of the power supply cable: RED wire (fig.3) must be DISCONNECTED. - RED wire (fig.3) must be DISCONNECTED. The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity (fig.1) - YELLOW wire (fig.1) must be connected to the +12V permanent/battery (fig.2) - BLACK wire (fig.2) must be connected to the GND. Multiconn Srl 2 Power supply cable1 2 3 (fig.4) DAS ® (fig.5) 2.Disconnect the original Fiber Optical cable (fig.4) from one of the original multimedia accessories inside the car (DVD, GPS, Amplifier, etc…) and match it directly to DAS ® fiber optic female connector of the harness on equipment (fig.5).4 45Installation: MERCEDES Activate the TV tuner with Diagnostic Mercedes System or through Engineering Menu. If TV tuner does not appear as option to set, DO NOT proceed with installation because the system does not support both the Original or aftermarket tuner. In this case it's possible to install the standard DAS receiver (NOT in fiber optic version) using the auxiliary video IN input and the remote control on equipment to command.
DAS ® (fig.6)(fig.7) DAS ® (fig.8) 3.Match the two other connectors of DAS ® harness (fig.6) respectively inside the original accessory (fig.7) and the other one inside DAS ® receiver (fig.8). DAS ® (fig.8)(fig.9) and the needed accessory (DCAB2FK-RCA in fig.9.1)(fig.10) 4.Connect one of the 3 DAS ® Video-OUT (fig.8) trough the adapter cables on equipment (fig.9) and the needed accessory (DCAB2FK-RCA in fig.9.1) with the Video-IN on the Head Unit (fig.10) by the dual green Fakra connector. Multiconn Srl 37 78 6 5 8 9 8 9.1 9.1 9MERCEDES
Multiconn Srl 4 Video-OUT WARNING brown fakra WARNING: if the Head Unit module has not the dual brown fakra connector, the car cannot accept an original or aftermarket TV tuner (fig.10) The back side of NTG4.5 Head Unit (fig.10). 10 10 9.1 9.1 Video-IN MERCEDES
User Manual: Multiconn Srl 5 DAS VIDEOTV tuner To enter in DAS TV tuner press VIDEO, then select TV tuner. DAS For the management of DAS receiver, use the arrow keys or the numeric keypad or the APS controller (joystick). WARNING: For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car and make sure that the format is congruent with the set menu on the DAS. MERCEDES Right rotation = UP on remote control (dropdown menu) Left rotation = Down on remote control (dropdown menu) Down Joystick Scroll= OK/Menu Right Joystick Scroll= Right arrow on remote Left Joystick Scroll= Left arrow on remote Comand APS controller Previous Channel (LEFT) Next Channel (RIGHT)
Multiconn Srl 6 Remote Control Functions: ON-OFF TURNING ON/OFF LEFT ARROW MENU NAVIGATION - ZAPPING KEY CONFIGURATION MENU/OK FUNCTIONS SET UP DAS MENU TV/RADIO SELECTION AND SEARCH SYSTEM NUMBER KEYPAD FOR CHANNEL PRE-SELECTION VOLUME ADJUSTMENT UP ARROW MENU NAVIGATION - ZAPPING KEY TV/AV1/AV2 SELECTION RIGHT ARROW MENU NAVIGATION - ZAPPING KEY DOWN ARROW MENU NAVIGATION - ZAPPING KEY PRESS CLEAR TO SWITCH TO EMULATION MODE DIRECTIONAL BUTTONS ON THE REMOTE CONTROL (5=OK) NUMBERS KEYPAD ARE EQUIVALENT TO REMOTE CONTROL MERCEDES