Presentation is loading. Please wait.

Presentation is loading. Please wait.

O T I M A T he T wisted P air T ransmission S ystem for CCTV S olution Presented by OTIMA CORPORATION 2006.

Similar presentations


Presentation on theme: "O T I M A T he T wisted P air T ransmission S ystem for CCTV S olution Presented by OTIMA CORPORATION 2006."— Presentation transcript:

1 O T I M A T he T wisted P air T ransmission S ystem for CCTV S olution Presented by OTIMA CORPORATION 2006

2 1. IntroductionP02 2. Video Transmission Range P03 3. General ApplicationsP04 4. UTP Cabling Transmission Product LineP05 Basic DIY Application p06 Video and Audio Transmission Applicationp07 Camera with Pan-Tilt Scanner Device Applicationp08 Speed Dome Camera Applicationp09 / p10 4 Cameras to Hub CCTV Distribution Applicationp11 4 Cameras Power from Cable Hub stationp12 4 Channel Hub to Hub CCTV Distribution Applicationp13 4 Cameras Video & Power Over One CAT 5 Cablep14 One Cable For Variety Range Applicationp15 Video, Power, Data Transmission Application p16 Multi-Port 8 or 16 CH Multiplexer / DVR Applicationp17 Building or Large CCTV installation with Rack cabinet p18 Smart PTZ Transmission and controller p19 5. Coaxial Cabling Transmission SolutionsP20 Video Distributor Applicationp21 Video Amplifier Application p22 Video Distribution Amplifier Applicationp23 6. Surge Protection DeviceP24 Surge Protection Applicationp25 7. CCTV Solution Provider for Different Video InterferenceP26 8. AC to DC, DC to DC Power Converter P27 9. Power Supply CenterP28 19 Rack Mounting 1U Panel & Wall Mounting Power Supply Center p28 / Accessories – Wire & ToolP30 1 INDEX

3 1. Introduction OTIMA twisted pair transmission products are designed for CCTV signal transmission over unshielded twisted pair cable (CAT 5 network cable). These smart cabling system transmission are an alternative solution to coaxial and fiber based systems, and providing following benefits: The fast, easy, and low-cost way to connect a CCTV camera to a monitor, multiplexer, or video recorder. Substantial savings on the cost of the cable itself. Superb quality on long range transmission 2

4 2. Video Transmission Range Passive: No power required Active: DC 12 volt or AC 24 volt power required Passive Transmitter Passive Receiver: Range: Color– 400m B/W – 600m Passive Transmitter Active Receiver: Range: 1000m Active Transmitter Active Receiver: Range: Color– 1500m B/W – 2400m * Using 2 sets series connection, B/W video transmission up to 3.6 Km, Color up to 3.0 Km * Short range may result when video transceiver are used with DVR 3

5 3. General Applications Perfect for or larger CCTV installations where need install many cameras, difficult in using coaxial cable, existing many interference environment. To Provide: Clear Video Signal, Fewer Cable to Manage, Lower Cost Per Connection, Centralized Wiring For Greater Control. Such As: Modern structured cabling systems in new construction Installations with a high camera count High Interference areas Where there is existing structured cabling School Campuses, Casinos, Hospitals, Apartment complexes Warehouses, Entry Gates, Elevator Parking Lot Power Plant Prisons Shopping Mall Traffic Control 4

6 4. UTP Cabling Transmission Product Line Following are the items with UTP transmission system for new generation CCTV solutions: Twisted Pair Transmission (Video, Audio, Data, Power) Video Distributor, Video Amplifier (Distribution Amplifier) Smart PTZ Transmission & Controller Surge Protection Device Solution Provider for different Video Interference Power Supply Center, Tooling, Accessories 5

7 Basic DIY Application The basic CCTV installation with UTP cabling transmission system 6

8 Video and Audio Transmission Application The video and audio transmission to monitoring station with range 600m (B/W), 400m (Color) 7

9 Camera with Pan-Tilt Scanner Device Application Using video transceiver with Retractile coiled cable on the camera to avoid cable bad connection or break when the pan-tilt device under operation. 8

10 Speed Dome Camera Application - 1 Using TTA111AV could transmit video, audio, 2 data signal, range up to 1.5 Km (Color), 2.4 Km (B/W) 9

11 Speed Dome Camera Application - 2 Using one 4 pair UTP cable to transmit / receive 4 sets video signals or using 3 pairs to transmit / receive 3 sets video signal, plus one data signal (RS-422, RS-485) 101

12 4 Cameras to Hub CCTV Distribution Application Four Cameras on different site and monitoring station are far away. Each camera connect to cable hub, then using one single CAT 5 cable to transmit 4 sets video signals to 4-channel video transceiver hub to monitoring station. (Quad/Multiplexer/DVR solution) 11

13 4 Cameras Power from Cable Hub station Camera power send from cable hub station (60 meters), then using one CAT 5 networking cable to transmit 4 sets video signal to monitoring station. 12

14 4 Channel Hub to Hub CCTV Distribution Application The range is near between four cameras: Using existing coaxial cable from camera to 4 channel TX Hub, over one cable to RX hub monitoring station. Ideal for cost saving of cable and easy installation. 13

15 4 Cameras Video & Power Over One CAT 5 Cable Use 4 pcs TTP111VP at camera side, work with TTP444VP could transmit 4 cameras video & power over one CAT 5 cable only. (Transmission range depending on power current, voltage) 14

16 One Cable For Variety Range Application Passive or active video transceiver for series connection to use one CAT 5 4 pairs cable, transmit 4 video signals for different range. 15

17 Video, Power, Data Transmission Application Using CAT 5 cable to transmit Video, Power, Data signal for best & professional cabling management. 16

18 Multi-Port 8 or 16 CH Multiplexer / DVR Application Using 8 or 16 receiver 1U panel on monitoring station, Professional 1U panel could reside in the same rack as other equipment, such as switcher, multiplexer, DVR... etc. 17

19 Building or Large CCTV installation with Rack cabinet Using rack card type, could insert passive or active receiver card at TRN012 Rack Cabinet, the maximum receiving channel could up to 60 channels (passive). 18

20 Smart PTZ Transmission and Controller OTIMA Smart PTZ Transmitter PCT017 can control PTZ Receiver (PCR011/017) up to 100 sets data single, only by using 2 wires (twisted pair) parallel connection. 19

21 5. Coaxial Cabling Transmission Solutions Video Distributor: if your installation calls for sending a video signal over Multiple monitors, use one of our video distributors. Video Amplifier Video Distributor Video Distribution Amplifier Video Amplifier: if your installation demands very long camera cable runs, use one of our video camera amplifiers to enhance video signal quality. Video Distribution Amplifier: this kind of device combines above 2 functions. 20

22 Video Distributor Application * Video Distributor * CD102: 1 input to 2 output, CD104: 1 input to 4 output, CD108: 1 input to 8 output, CD116: 1 input to 16 output CD408: 4 input to 8 output, CD816: 8 input to 16 output CD1664: 16 input to 64 output in 2U rack mounting panel Using CD104 transmit One video signal to Four monitors (destination devices) without Video Loss CD816 CD408 CD1664 CD104 21

23 Video Amplifier Application * Video Amplifier * with Sharpness, Brightness Controls CA101: 1 input to 1 output CA101A: 1 input to 1 output with Audio CA404: 4 input to 4 output CD101VH: 1 input to 1 output HF / MF / LF compensation Using CA404 for 4 channel Video amplifications, range could up to 1000 meters with using RG59 coaxial cable CA404 22

24 Video Distribution Amplifier Application * Video Distribution Amplifier * with Sharpness, Brightness Controls CD102A: 1 input to 2 output CD408A: 4 input to 8 output with Audio CD816A: 8 input to 16 output in 1U panel Using CD102A for 1 IN 2 OUT Distribution Amplifications, Range could up to 1000 meters with using RG59 coaxial cable on each channel. CD408ACD102A CD816A 23

25 6. Surge Protection Device Coaxial End up throwing away the camera system you Installed just because your equipments were hit with lightning. Using OTIMA Surge Protectors to protect your equipment from high voltage surges from nearby lightning strikes. Twisted PairVideo & DataNetwork 1U rack mounting panel – Excellent for DVR Protection 24

26 Surge Protection Application Using low cost OTIMA Surge Protection Products to protect your high value CCTV equipments. 25

27 7. CCTV Solution Provider for Different Video Interference Before Use After Use Video Ground Loop Isolator: it could reduce Ground Loop Interference with CCTV signals and can easily install in a new or added to existing systems. It is useful where a video signal is transmitted via cable between points with different ground potentials, differences in ground potentials a typically caused by unbalanced power line loads. Video Transformer Filter: The reason to cause rolling image is from the power interference during transmission or the video transmission range is too big between 2 or multi channels to have the signal not balanced. Using the Video Transformer Filter to extra interference rejection. High Frequency Interference Blocker: Block the interference from electromagnetic wave, high voltage electricity, wireless station, with Video Transformer Filter function Video Ground Loop Isolator Video Transformer Filter High Frequency Interference Blocker 26

28 8. AC to DC, DC to DC Power Converter For DC type camera or video power sources convert using AC24V for professional CCTV industry installations AC14V – AC24V to DC12V DC15V – DC30V to DC12V PC300 / PC500 PC1A * AC to DC, DC TO DC Power Converter* PC300: 300mA Max. (Regulated) PC500: 500mA Max. (Regulated) PC1A: 1000mA Max. (Regulated) AC to DC, DC to DC regulated AC24V convert to DC12V regulated AC14V – AC24V convert to DC12V regulated DC15V – DC30V convert to DC12V regulated To Camera 27

29 9. Power Supply Center – 19 Rack Mounting 1U Panel OTIMA PR801, PR816 both are 8 AMP AC24V or DC12V power supply in 19 standard 1U rack mounting cabinet. It is perfect to install in the control room. Application for larger industry CCTV installation where need numbers of camera, housing, pan tilt turning device or other Surveillance equipments power sources from building control room. 28

30 Power Supply Center – Wall Mounting OTIMA PW408, PW816 are 4 AMP, 8 AMP DC12V/ DC24V, or AC24V power supply At Wall Mounting Type. It is perfect to install in the control room. Application for larger industry CCTV installation where need numbers of camera, housing, pan tilt turning device or other Surveillance equipments power sources from building control room. 29

31 10. Accessories – Wire & Tool Coaxial & Twisted Pair Cable Tool kits Cable tester Accessories Parts & Connectors OTIMA also offer a series of Wire & Tool products to use on Coaxial, Twisted Pair Installation. 30

32 CATALOGUE DOWNLOAD : OTIMA UTP Transmission OTIMA UTP Transmission (pdf, 4.68MB) OTIMA UTP Transmission Go to Index Page Go to OTIMA website


Download ppt "O T I M A T he T wisted P air T ransmission S ystem for CCTV S olution Presented by OTIMA CORPORATION 2006."

Similar presentations


Ads by Google