Presentation is loading. Please wait.

Presentation is loading. Please wait.

Lathe Quiz Answer the following questions by left clicking the mouse on the appropriate part of the Wood Lathe.

Similar presentations


Presentation on theme: "Lathe Quiz Answer the following questions by left clicking the mouse on the appropriate part of the Wood Lathe."— Presentation transcript:

1

2 Lathe Quiz Answer the following questions by left clicking the mouse on the appropriate part of the Wood Lathe.

3 Copper 1.Where is the tailstock ?

4 Copper Tailstock The tailstock is used to support one end of the work piece when turning between centres.

5 Copper 2. Where is the toolrest ?

6 Toolrest The Toolrest is used to support the lathe tool when turning

7 Copper 3. Where is the Forked Centre ?

8 Forked Centre The Forked Centre supports the other end of the work piece.

9 Copper 4. Where is the Lathe Bed?

10 Lathe Bed The Lathe Bed is made from cast Iron and machined flat to allow the tailstock to slide freely along its length

11 Copper 5.Where is the Revolving Centre?

12 Copper Revolving Centre The Revolving Centre supports the other end of the work piece.

13 Copper 6. Where is the Headstock?

14 Headstock The Headstock contains the Drive shaft and Pulleys.

15 Copper 7. Where is the Isolator?

16 Isolator The Isolator is used to Isolate the Lathes power supply.

17 8. Which of the above Lathe tools is a Parting tool?

18 The parting tool can be used to cut narrow slots in your work piece. The Parting tool

19 9. Which of the above Lathe tools is a Gouge?

20 The Gouge utilises a slicing action and can be used for both roughing down and fine finishing The Gouge Cross Section

21 Copper 10. Which of the above Lathe tools is a Skew Chisel?

22 Copper The skew chisel can be used to produce a very smooth finish The Skew Chisel When using this tool remember only to use the bottom third of the blade

23 Copper 11. Which of the above Lathe tools is a Scraper?

24 Copper The Scraper Scrapers are among the easiest lathe tools to use however as the name suggests the tool scrapes rather than cuts and can leave a rather rough finish. Scrapers are available in a wide range of shapes and sizes.

25 12. Which of the tools shown on the left is a faceplate ?

26 A Faceplate is used to attach a wood blank to the lathe when making a bowl The Faceplate Faceplate

27 Congratulations you have finished the Wood Lathe Quiz


Download ppt "Lathe Quiz Answer the following questions by left clicking the mouse on the appropriate part of the Wood Lathe."

Similar presentations


Ads by Google