1. 100% Exam Passing Guarantee & Money Back Assurance
Pass Dumps - CCIE Wireless (v3.1) in just 24 HOURS!
100% REAL EXAM QUESTIONS ANSWERS
Dumps - CCIE Wireless (v3.1)
Buy Complete Questions Answers File from
dumps.html
100% Exam Passing Guarantee & Money Back Assurance
Sample Questions

2. Question No 1: Answer: A, C Question No 2: Answer: B, C
Refer to the exhibit, based upon the given configuration which two statement are true? (choose two)
local RADIUS server is used
No password is required everyone can join wireless network
Users will be required to provide a username and password for authentication
User will be required to provide a password only order to get access E. Remote RADIUS servers is used
Answer: A, C
Question No 2:
Which two features require Network Time Protocol synchronization on the Cisco WLC?(Choose two)
AP CAPWAP multicast
SNMPv3
AP authentication
Band Select
Answer: B, C

3. Question No 3: Answer: C Question No 4:
Refer the exhibit. the created dynamic interfaces are bound to an interface group for a specific WLAN profile in a Cisco Wireless LAN Controller.
You have noticed duplicated multicast streams on the wireless medium for the given WLAN profile. Which statement is correct?
Globalmulticast mode,globai 1Pv6 config,and multicast listener discovery snooping have not been enabled. Enable this to avoid duplicate streams.
Global multicast mode and internet group management protocol snooping have not been enabled . To avoid stream enable both .
The controller creates different multicast groups IDs for each multicast address and VLAN and a result the upstream router sends one copy for each VLAN. Enable Multicast VLAN to avoid duplicate streams.
The controller always uses layer 3 multicast group 10 for all layer 3 multicast traffic sent to the access point internet group management protocol snooping should be disabled to avoid duplicate streams.
Answer: C
Question No 4:
Two autonomous Aps are connected to a switch on the same VLAN both APS are configured with the same SSID and WPA2-PSK.
After making configuration changes to one of the APs .spanning tree disabled one of the switch ports into which AP was plugged?
Which two options describe possible reasons that spanning tree disabled a port? (choose Two)
One of the Aps was configured as a universal workgroup bridge.
It is not possible for spanning tree to disable a port. The bridging loop must have been coincidental
Spanning tree was disabled on both Aps

4. Answer: A, E Question No 5:
PortFast was enabled on all ports
One of the APs was configured as a standard workgroup bridge.
Answer: A, E Question No 5:
Which two statement about LAG in the Cisco wireless LAN controller running Aire OS 8.0 are true?(choose two)
LAG bundles all of the crsco WLC distribution system ports into a single 802.3ad port channel.
There can be only one AP-manager interface if LAG is enabled
LAG configuration change take effect immediately after they are configured
Channel negotiation LACP and PAgP are supported
Answer: A, B Question No 6:
You have configured video stream on a Cisco WLC and users are now viewing the company video broadcast over the wireless network, how can you verify you have video stream configures and working in the cisco WLC GUI?
The multicast status shows "normalmulticast" in the multicast group detail
The multicast status shows "MediaStream allowed" in the multicast group detail
The WMM state shows "Enabled" into the clients detai
The multicast status shows "multicast-direct allowed" in the multicast group detail
Answer: D Question No 7:
Refer to the exhibit. APs on VLAN 2100 can get IP address but cannot register to the WLC. The iP address of the WLC management interface is Which option is the correct DHCP option 43 configuration.?
A. f10412f41cd9
B. f10418f404227
C. f10818f41cd0a181cf4a01c
D. f10418f404e3
E. f1040a3f0701
Answer: D

5. PDF Version + Test Engine Software Version
Question No 8:
Which two statement describe characteristics of high availability cisco 5760wireless LAN controller that uses the stackwise-480 technology?(choose two)
A switch stach has only three WLCs one active WLC and two standby WLCs
lf the WLC become unavailable the standby assumes the role of the active and continue to the keep the stack operational.
A switch stack has only Two WlCs both WLCs are in active/active mode
A switch stack has only two WLCs one active and one standby WLC.
Answer: B, D
Buy Complete Questions Answers File from
PDF Version + Test Engine Software Version
90 Days Free Updates Service
Valid for All Countries