1. ESTeem 195 Narrowband Series
SECTION 11 - Wireless Serial Overview
ESTeem 195 Narrowband Series

2. ESTeem Licensed VHF & UHF
Longer Range Applications
Exclusive Use of FCC Frequency
Serial and Ethernet Interfaces
MHz - VHF (Complies with 2013 FCC Narrowband Mandate)
MHz – VHF (New Frequency Open for Data Radios)
450–470 MHz - UHF (Complies with 2013 FCC Narrowband Mandate)
Licensed Serial and Ethernet

3. Model 195 Narrowband Series Layout
Ethernet/RS-422 Port
Reset Switch
RS-232 Port
RS-232 Remote Power
Tri-Color
Status/TX/RX LED
Aux Power LED
12 VDC Input (Auxiliary Connector )
4/20mA Sensor/
RS-485 Port
Remote Power LED

4. Model 195M Model 195M Features 150-174 MHz Modes Narrowband - Licensed
SECTION 4 - ESTeem Overview
Features
MHz
Narrowband - Licensed
Ethernet and Serial Communications
12.5 Kbps RF data rate
Watt RF Output
10+ miles Line-of-Sight Range
Internal Spectrum Analyzer
Model 195M
Modes
Ethernet Networks;
Ethernet Bridge, Telnet Console, Repeater
Serial Networks;
Point–Point, Point-Multipoint, Repeater
PLC Protocol Emulation
AB DF1/Ethernet, Modbus/TCP, Opto-22

5. Model 195H Model 195H Features 217 - 220 MHz Modes
SECTION 4 - ESTeem Overview
Features
MHz
Narrowband - Licensed
Ethernet and Serial Communications
Kbps RF data rate
Watt RF Output
10+ miles Line-of-Sight Range
Internal Spectrum Analyzer
Model 195H
Modes
Ethernet Networks;
Ethernet Bridge, Telnet Console, Repeater
Serial Networks;
Point–Point, Point-Multipoint, Repeater
PLC Protocol Emulation
AB DF1/Ethernet, Modbus/TCP, Opto-22

6. Model 195C Model 195C Features 450-470 MHz Modes Narrowband - Licensed
SECTION 4 - ESTeem Overview
Features
MHz
Narrowband - Licensed
Ethernet and Serial Communications
12.5 Kbps RF data rate
Watt RF Output
10+ miles Line-of-Sight Range
Internal Spectrum Analyzer
Model 195C
Modes
Ethernet Networks;
Ethernet Bridge, Telnet Console, Repeater
Serial Networks;
Point–Point, Point-Multipoint, Repeater
PLC Protocol Emulation
AB DF1/Ethernet, Modbus/TCP, Opto-22

7. Modes of Operation Serial Data Transfer Ethernet Bridge Mode
Transparent
PLC Emulation Modes
Serial Data Transfer
Point to Point/Multipoint
Repeaters Supported
Ethernet Bridge Mode
Four 4/20mA Inputs
Remote I/O

8. Configuration
Flash Utility for all computer operating systems (Windows/Linux/Mac)
Found in Tools folder of new Discovery Utility
Narrowband Configuration Utility
No serial port on computer required for programming
Programmed through Ethernet Interface
Select Data Interface (SDI)
Select Mode of Operation

9. Serial Data Transfer RS-232 (Full and Remote 3-Wire) RS-422 RS-485
Serial Data Interface (SDI)
Rockwell – DF1 Full-Duplex, DF1 Half-Duplex, DF1 Radio Modem
Modbus – RTU and ASCII Modes
Opto-22
DNP V3 – Power Utility Protocols
PLC Emulation Modes
Transparent

10. Ethernet Data All Ethernet device IP addresses must be listed
Remote ESTeem modems and connected devices
Ethernet Bridging
Used to identify repeater routes
Used to create “group” of IP addresses serviced by remote modems
Routing and Append Tables
Only IP addresses listed in routes/appends will be sent over radio link
Easy “router” functionalilty
Very Tight IP Address Control

11. Model 192 Compatibility Model 192 radio modems must be narrowband
Best used at remote locations
Model 195C/195M Designed for Model 192 Network
Slower 9,600 bps RF data rate
Runs in “Non-Native” Mode
192 Compatibility in Narrowband Utility
Matches deviation level to a specific Model 192 in network
Training Required

12. Troubleshooting Displays transmissions, retries and link down
Current Receive Signal Strength (RSSI)
Diagnostic Utility
Enter through Utility or Telnet to IP address
Packet Monitor – Displays all RF activity
System Dump – Displays all interface (serial or Ethernet) activity
Console
Spectrum Analyzer in Utility software
Analyzer
Firmware version stored in each Utility version
Firmware Update

13. Programming Tips Address, Radio ON, Connect, Disconnect, etc.
See User’s Manual for complete command list
Many Basic Model 192 Commands Supported in Console
TCP/IP address
Last Octet used for single address
Example IP Address (209) – Unit address = 209
Modem Address
Advanced configuration
Read Configuration>Change Power Level>Write Configuration
Setting RF Power Level

14. Programming Tips PROG Command from Console – Model 192 type responses
Enter Remote IP address in Utility and select Remote radial
Remote Programming
Right mouse click anywhere in Advanced Configuration screen
Save/Load Configuration