1. Vehicle Registration Details Extraction System Using GSM

2. AGENDA Introduction Block Diagram Power Supply&Testing
Micro-Controller&Testing
GSM module&Testing
RFID module&Testing
IR Sensor
LCD module&Testing
Problems
Refference

3. Introduction Heavy Rainy season Chances of accident
To Control the Traffic Rule
The project addresses microcontroller based Vehicle Registration details Extraction system using GSM

4. Block Diagram

5. CKT DIAGRAM

6. Power Supply
Regulated dc power supply
Output=5v
component

7. Testing of Power Supply

8. Microcontroller ■ 80C51 Central Processing Unit
■5 V Operating voltage from 0 to 40 MHz
■64 kB of on-chip Flash program memory
■ Four 8-bit I/O ports with three high-current Port 1 pins
( 16 mA each)
■Three 16-bit timers/counters
■Programmable Watchdog timer (WDT)
■Eight interrupt sources with four priority levels
TTL- and CMOS-compatible logic levels

9. Testing of Microcontroller

10. FACED PROBLEMS Crystal Reset Power Supply Poor pin contacts
Syntax Errors
Undefined Symbol

11. GSM Module

12. Features of GSM Single supply voltage 3.2v-4.5v
Typical power consumption in SLEEP Mode: 2.5mA.
SIM300 tri-band

13. Testing with a PC Connect the GSM Modem to a PC COM Port
Create a HyperTerminal (Windows tool for serial port communications) window with Baud rate 9600 and connect it to the COM Port to which GSM is connected.
Type any AT command in the HyperTerminal window and you could see the modem responding by sending “OK”.

14. Testing with a PC

15. Faced Problems Connections setting Matching proper Baud rate
Serial port communication

16. IR Sensor
Obstacle detection

17. Testing OF IR Sensor

18. RFID Module Radio-frequency identification(RFID)
An RFID system is just a reader and a tag communicating over the air at a certain frequency
Parts
– Readers
– Antennas
– Tags
Fig 1: An RFID tag used for electronic toll collection.

19. LCD • 2 line x 16 character Display
• Each character location consist of 5 dot x 8 bit display
4bit or 8bit MPU interface
Memory map

20. Testing OF LCD Establish connection with Microcontroller
Load Program for transmitting string.
Check Data lines of LCD.
Adjust Potentiometer.

21. PROBLEMS Loose Connection. LCD Initialization.
Display String operation
LED+
LED-

22. Refference
Timo H.,Javier R. and Jaun M.2003.GSM,GPRS and Performance and Ed. Chichester:John Wiley And Sons,Ltd.
I.Pottier and G.Burel,” Identification and authentication of handwritten signatures with a connectionist approach,” in Proc.IEEE Int.

23. THANK YOU