Presentation is loading. Please wait.

Presentation is loading. Please wait.

RF Module Integration Colin Whyte University of Strathclyde on behalf of the MICE collaboration 1RF Review 9th & 10th Sept '15 Abingdon.

Published byAlannah Kennedy Modified over 7 years ago

Similar presentations

Presentation on theme: "RF Module Integration Colin Whyte University of Strathclyde on behalf of the MICE collaboration 1RF Review 9th & 10th Sept '15 Abingdon."— Presentation transcript:

1 RF Module Integration Colin Whyte University of Strathclyde on behalf of the MICE collaboration 1RF Review 9th & 10th Sept '15 Abingdon

2 2 Outline Interfaces High power RF co-axial lines Vacuum Window protection Vacuum volume dimensions and pumping Temperature - control Cavity tuning – air Connections to magnets Bellows Flange bolt pattern Quench force Sliding platforms Clean room End flanges Controls and Monitoring Interlocks RF Power amplifiers Vacuum Temperature – independent Cavity tuning – LabView LLRF – offline test Muon Timing Safety Ionising radiation High voltage for RF amplifiers

3 Demonstration of Ionisation Cooling 3RF Review 9th & 10th Sept '15 Abingdon RF power transmission overhead SF6 filled co-ax lines Relatively easily de- mountable

4 Flexible coax Line Trimmers Hybrid Splitter Directional Coupler in each line 4616 Pre Amplifier TH116 Amplifier 500kW Load Directional Coupler 6 inch RF Power 4RF Review 9th & 10th Sept '15 Abingdon Simplified distribution network- overhead Off-centre mounting of hybrid takes up phase shift Minimised length of 4” line- minimises losses

5 Co-axial line support 5RF Review 9th & 10th Sept '15 Abingdon Coax support structure Drill and tap PRY for 2 off vertical upright supports Steve Plate & Holger don’t see this as a problem Fasten Coax support frame to uprights

6 Offline support frame 6RF Review 9th & 10th Sept '15 Abingdon

7 7 NEW RF SUPPORT PILLAR POSITIONS RF MODULE Co-Axial line trimmer supports SUPPORT PILLAR POSITIONS TAKEN FROM DRG NO TD-1173-0919 DOWNSTREAM AFC UPSTREAM AFC

8 RF module vacuum 8RF Review 9th & 10th Sept '15 Abingdon Large, complicated vacuum volume – 2 large turbo-pumps mounted to central spool, located behind south side of PRY with large bore pump path Note T Anderson talk on Be window protection.

9 Cavity temperature 9RF Review 9th & 10th Sept '15 Abingdon Cavity on frequency at 36.5 degrees Water flow rates on cavity restricted due to small cooling pipes 0.05 degrees cavity temperature stability can be achieved RF trips result in cavity detuning which can again take 5 minutes to recover from RF is always applied at effectively maximum Temperature stabilisation system with heater, cold water and mixing valve control by high resolution process controller that self learns

10 MTA Cavity results 10 B=0 0.5M+ pulses at >11MV/m 14MV/m for short periods. No evidence of breakdown B=5T >7.5M pulses 1M @ 8MV/m 3M @ 10.7-11.2MV/m 1.3M @ 13-13.7MV/m 0.36M @ 13.8-14.5MV/m No breakdown below ~14MV/m RF Review 9th & 10th Sept '15 Abingdon

11 Cavity Tuning 11RF Review 9th & 10th Sept '15 Abingdon 0.5M pulses 5Hz, B=5T, 1.6MW (10.3MV/m) 1.4kW ave, 1Hz update interval

12 Vacuum connections 12RF Review 9th & 10th Sept '15 Abingdon 692.15mm OD x 539.75mm ID nested bellows : Extended length 66mm Closed length 14mm Stroke 52mm nom free length 40mm Axial stiffness 200N/mm. 316L, 0.91mm thk. End terminals: 316.

13 Quench Forces 13RF Review 9th & 10th Sept '15 Abingdon

14 14RF Review 9th & 10th Sept '15 Abingdon RF CAVITY MODULE MOVING PLATFORM (TOP VIEW) EXISTING AFC MOVING PLATFORM ARRANGEMENT RF MODULE C of G LINE RF MODULE FRAME FOOTPRINT EXISTING SS TIE-DOWN ARRANGMENT (DOWNSTREAM) PLATFORM TRANSIT ROLLERS SPACED AT MAX. SPAN IN AVAILABLE ENVELOPE BETWEEN FLOOR BEAMS HOWEVER MODULE LOAD OFFSET OFFSET 98 360 CTR

15 RF Review 9th & 10th Sept '15 Abingdon RF CAVITY MODULE MOVING PLATFORM ARRANGEMENT OPTIONS (TOP VIEW) EXISTING AFC MOVING PLATFORM ARRANGEMENT PROPOSED RF MODULE MOVING PLATFORM ARRANGEMENT EXISTING SS TIE-DOWN ARRANGMENT EXISTING AFC MOVING PLATFORM ARRANGEMENT PROPOSED RF MODULE MOVING PLATFORM ARRANGEMENT EXISTING SS TIE- DOWN ARRANGMENT 15 OPTION 1OPTION 2 DOWNSTREAM SPECTROMETER UPSTREAM SPECTROMETER

16 Cooling Demonstration 16RF Review 9th & 10th Sept '15 Abingdon

17 Partial Return Yoke (PRY) 17 Flux return path to protect sensitive equipment from fringe field of magnet chain. 100mm thick soft iron plate Step IV PRY re-used and extended for cooling demonstration. Extension also made in the USA, drawings complete, ready to go to contract. New, extended support structure made in UK. New floor fixings required RF Review 9th & 10th Sept '15 Abingdon

18 RF Module End Plates 18RF Review 9th & 10th Sept '15 Abingdon RF Module end plates are heavy, 3-400kg. Require hoist/frame in clean room. Cannot flow significant clean gas to preserve cleanliness because of fragile windows. Replace Vac flanges with thin/light ‘clean’ plates which allow insertion into beamline. Build structure around magnets and fit to clean room extension.

19 19RF Review 9th & 10th Sept '15 Abingdon RF system overall control State machine control RF measurements Important vacuum /voltage/ temperature parameters Interlock status and trips Illustration shows the main operator panel for ALICE more in-depth control pages are clickable from this main screen

20 Off-line Testing 20RF Review 9th & 10th Sept '15 Abingdon RF Module RF Amplifier Area

21 Cooling Demonstration Installation start 1 st June 2016. 2 RF cavities, 2 secondary absorbers bracketing main absorber 21RF Review 9th & 10th Sept '15 Abingdon Extended Partial Return Yoke – USA 2 x 201MHz cavities - USA Be windows Tested in B field to 14MV/m 2 x 2MW 201MHz amplifier chains – UK RF infrastructure support - UK RF controls and monitoring – UK Muon phase determination - UK

22 i RF Review 9th & 10th Sept '15 Abingdon22

Download ppt "RF Module Integration Colin Whyte University of Strathclyde on behalf of the MICE collaboration 1RF Review 9th & 10th Sept '15 Abingdon."

Similar presentations

Andrew Moss ASTeC MICE RF workshop 16t h February 2012 Daresbury Laboratory Response to RF review for the MICE RF system.

Andrew Moss ASTeC MICE RF workshop 16t h February 2012 Daresbury Laboratory Response to RF review for the MICE RF system.
RF Specification discussion MICE RF workshop 16 th April 2012.

RF Specification discussion MICE RF workshop 16 th April 2012.
MICE RF and Coupling Coil Module Outstanding Issues Steve Virostek Lawrence Berkeley National Laboratory MICE Collaboration Meeting October 26, 2004.

MICE RF and Coupling Coil Module Outstanding Issues Steve Virostek Lawrence Berkeley National Laboratory MICE Collaboration Meeting October 26, 2004.
Collaboration meeting, RAL, 4 th – 7th November 2009 Andrew Moss ASTeC Collaboration meeting, RAL, 10 th – 13 th november 2009 MICE RF Amplifier Status.

Collaboration meeting, RAL, 4 th – 7th November 2009 Andrew Moss ASTeC Collaboration meeting, RAL, 10 th – 13 th november 2009 MICE RF Amplifier Status.
RF systems for MICE Andrew Moss The MICE RF Group and the TIARA WP7 Team Contributions include Daresbury, RAL, CERN, LBNL, LANL, FNAL, Strathclyde & Sheffield.

RF systems for MICE Andrew Moss The MICE RF Group and the TIARA WP7 Team Contributions include Daresbury, RAL, CERN, LBNL, LANL, FNAL, Strathclyde & Sheffield.
Andrew Moss Daresbury Laboratory Collaboration Meeting 34 15 th 19 th October 2012 RAL MICE RF System review.

Andrew Moss Daresbury Laboratory Collaboration Meeting th 19 th October 2012 RAL MICE RF System review.
RF Layout 3pi/2 for Discussion. 2 RF Design mtg 14/1/15 Output line from amplifier is lower than the PRY, needs to go high to clear PRY to couple to South.

RF Layout 3pi/2 for Discussion. 2 RF Design mtg 14/1/15 Output line from amplifier is lower than the PRY, needs to go high to clear PRY to couple to South.
23 October 2005MICE Meeting at RAL1 MICE Tracker Magnets, 4 K Coolers, and Magnet Coupling during a Quench Michael A. Green Lawrence Berkeley Laboratory.

23 October 2005MICE Meeting at RAL1 MICE Tracker Magnets, 4 K Coolers, and Magnet Coupling during a Quench Michael A. Green Lawrence Berkeley Laboratory.
Status of the 201 MHz Cavity and Coupling Coil Module Steve Virostek Lawrence Berkeley National Laboratory MICE Video Conference March 10, 2004.

Status of the 201 MHz Cavity and Coupling Coil Module Steve Virostek Lawrence Berkeley National Laboratory MICE Video Conference March 10, 2004.
Installation Issues Steve Virostek Lawrence Berkeley National Lab MICE CM23 at ICST, Harbin January 13, 2009.

Installation Issues Steve Virostek Lawrence Berkeley National Lab MICE CM23 at ICST, Harbin January 13, 2009.
Progress on the MICE 201 MHz Cavity Design Steve Virostek Lawrence Berkeley National Lab RF Working Group Fermilab August 22, 2007  automatic.

Progress on the MICE 201 MHz Cavity Design Steve Virostek Lawrence Berkeley National Lab RF Working Group Fermilab August 22, 2007  automatic.
Safety Review: RF Issues Derun Li Absorber Safety Review December 9-10, 2003 Lawrence Berkeley National Laboratory Berkeley, CA 94720.

Safety Review: RF Issues Derun Li Absorber Safety Review December 9-10, 2003 Lawrence Berkeley National Laboratory Berkeley, CA
1 Status of infrastructure MICE Video Conference, August 17, 2005 Yury Ivanyushenkov Applied Science Division, Engineering and Instrumentation Department.

1 Status of infrastructure MICE Video Conference, August 17, 2005 Yury Ivanyushenkov Applied Science Division, Engineering and Instrumentation Department.
MuCool RF Status MICE Collaboration Meeting June 7-10, 2006, Fermilab A. Moretti June 9, 2006.

MuCool RF Status MICE Collaboration Meeting June 7-10, 2006, Fermilab A. Moretti June 9, 2006.
MICE Collaboration Meeting Harbin, China 13 – 17 January 2009 Integration Issues By Wing Lau, Oxford University.

MICE Collaboration Meeting Harbin, China 13 – 17 January 2009 Integration Issues By Wing Lau, Oxford University.
CRYO PIPING & INTER-MODULE CONNECTIONS Yun He, Daniel Sabol, Joe Conway External Review of MLC Daniel Sabol, MLC External Review 10/3/2012.

CRYO PIPING & INTER-MODULE CONNECTIONS Yun He, Daniel Sabol, Joe Conway External Review of MLC Daniel Sabol, MLC External Review 10/3/2012.
1 Presented at ColUSM by D. Ramos on behalf of the Cold Collimator Feasibility Study Working Group https://espace.cern.ch/CCFS/default.aspx Longitudinal.

1 Presented at ColUSM by D. Ramos on behalf of the Cold Collimator Feasibility Study Working Group Longitudinal.
Alignment and assembling of the cryomodule Yun He, James Sears, Matthias Liepe MLC external review October 03, 2012.

Alignment and assembling of the cryomodule Yun He, James Sears, Matthias Liepe MLC external review October 03, 2012.
Assembly, Installation and Interfaces Steve Virostek Lawrence Berkeley National Lab RFCC Module Design Review October 21, 2008.

Assembly, Installation and Interfaces Steve Virostek Lawrence Berkeley National Lab RFCC Module Design Review October 21, 2008.
Andrew Moss ASTeC 7 th December 2011 MICE RF System.

Andrew Moss ASTeC 7 th December 2011 MICE RF System.

Similar presentations

Ads by Google