Download presentation
Presentation is loading. Please wait.
Published byGwen Parks Modified over 8 years ago
1
1 MC B1 Inspection MTM data: 65708-1 FIDUCIALS.IGS 65708-1 DATA.IGS 9/26/06 Pro/E model: b1_mtm_data_check.asm
2
2 Profile of M to MI: 114 point are OOT. Max + = 0.0129” OOT Max - = -0.0152” OOT
3
3 M-M1 SIDE-A OOT.013
4
4 M-M1 SIDE-A OOT.015
5
5 N-N1 SIDE-B OOT.022 Profile of N to NI: 93 point are OOT. Max + = 0.022” OOT Max - = -0.0167” OOT
6
6 MC Type-A to Type-B large wing interface clearance is 0.378” in the CAD model. Type-B wing Type-A wing pocket
7
7 -.062 / -.088 +.023 / +.039 +.092 / +.098 +.009 / +.036 -.074 / -.086 -.006 / -.025 MC Type B Wing – Flange D Side: The machine surface is acceptable. SIDE-A OUTER WING -.12/-.25
8
8 MC Type-A to Type-B large wing pocket interface clearance is 0.358” in the CAD model. SIDE-A INNER POCKET +0 / -.12
9
9 MC Type B Wing Pocket – D Side: The machine surface is acceptable..096.114.084.115.001 -.107 -.145 In general most area has a negative surface cut except where noted. See next slide for MTM data. Surface data measures slightly different for MTM data. I assume due to shift caused by best fit. +.111 +.023 +.093
10
10 MTM inspection data for MC Type B Wing Pocket – Flange D Side
11
11 MC Type-A to Type-B small wing pocket interface clearance is 0.445” in the CAD model.
12
12 Pocket 2 Flange D Side +0.087 +0.195 +0.218 +0.217 +0.208 +0.38 +0.033 +0.041 +0.214 +0.117 MTM inspection data Surface data measures slightly different for MTM data. I assume due to shift caused by best fit.
13
13 0.32” minimum clearance to nominal CAD surface. MC Type-A to Type-B small wing pocket: The machine surface is acceptable.
14
14 MC Type-C to Type-B large wing pocket minimum interface clearance is 0.249” in the CAD model.
15
15 Pocket E Side: All negative surface values. The machine surface is acceptable. -.052 / -.115 -.020 / -.936 -.020 -.229 -.670 -.730 -.621 -.936 -.74 -.071 -.086 -.081 Nominal part thickness remaining is 2.48”
16
16 PROFILE OF INSIDE CAST D SIDE Point offset is.459”. OOT by 0.25” Surface acceptable Point offset is.316”. OOT by 0.065”
17
17 WE COULD NOT FIND FLANGE SURFACE DATA
Similar presentations
© 2024 SlidePlayer.com Inc.
All rights reserved.