Presentation is loading. Please wait.

Presentation is loading. Please wait.

Chapter 7 Criterion-Referenced Measurement PoorSufficientBetter.

Similar presentations


Presentation on theme: "Chapter 7 Criterion-Referenced Measurement PoorSufficientBetter."— Presentation transcript:

1 Chapter 7 Criterion-Referenced Measurement PoorSufficientBetter

2 Criterion-Referenced Testing Mastery Learning Standard Development Judgmental Normative Empirical Combination

3 Guidelines for Writing Behavioral Objectives (Mager, 1962) Identify the desired behavior by name Define the desired behavior Specify the criteria of acceptable performance

4 Advantages of Criterion-Referenced Measurement Represent specific, desired performance levels linked to a criterion Are independent of the proportion of the population that meets the standard If not met, specific diagnostic evaluations can be made Degree of performance is not important... reaching the standard is

5 Limitations of Criterion-Referenced Measurement Cutoff scores always involve subjective judgment Misclassifications can be severe Students who meet the cutoff may no longer be motivated to do better

6 Setting a Cholesterol “Cut-Off” Cholesterol mg/dl N of deaths

7 Setting a Cholesterol “Cut-Off” Cholesterol mg/dl N of deaths

8 Statistical Analysis of CRTs Nominal Data Contingency Table Development Phi Coefficient (PPM) Chi-Square Analysis

9 Considerations with CRT The same as norm-referenced testing Reliability Consistency of measurement Validity Truthfulness of measurement

10 Figure 7.1 (a) FITNESSGRAM Standards 24 (4%) 21 (4%) 64 (11%) 472 (81%) Did not achieve the standard on the run/walk test Did achieve the standard on the run/walk test Below the criterion VO 2max Above the criterion VO 2max

11 Figure 7.1 (b) AAHPERD Physical Best Standards 130 (22%) 23 (4%) 201 (35%) 227 (39%) Did not achieve the standard on the run/walk test Did achieve the standard on the run/walk test Below the criterion VO2max Above the criterion VO2max

12 Meeting Criterion-Referenced Standards Possible Decisions Truly Below Criterion Truly Above Criterion Did not achieve standard Correct Decision False Positive Did achieve standard False Negative Correct Decision

13 Table 7.1 Test-Retest Reliability Example Day 2 Day 1Did not achieve the standard Did achieve the standard Did not achieve the standard 8020100 Did achieve the standard 50250300 100400 P =.825 K =.576 Phi =.586  2 = 137.13, df = 1, p <.001

14 Table 7-2 Criterion-Referenced Equivalence Reliability Between the 1 Mile Run/Walk and PACER TestsTotal sampleBoysGirls Trial 1 P.76.83.66 K.51.65.33 Trial 2 P.71.76.65 K.43.52.30

15 Figure 7.3 A theoretical example of the divergent group method

16 Examples of Criterion Referenced Standards Cholesterol < 240 mg / dl Systolic Blood Pressure < 140 mmHg Diastolic Blood Pressure < 90 mmHg FITNESSGRAM 1-mile run time for boy age 10 < 11:30 President’s Challenge Health Fitness curl-ups girl age 14 > 24

17 CRT Reliability Fail Day 1 Pass Fail Pass Day 2

18 CRT Validity Fail Field Test Pass Fail Pass Criterion

19 Racquetball Example Can a wall volley test serve as a good criterion measure to determine who should enter intermediate racquetball? Example Reliability study Validity study

20 2 extra racquetballs You must always hit the ball from behind the broken line Front Wall The test 4 attempts 30 secs each Trial 1 attempts 1 + 2 Trial 2 attempts 3 + 4

21 Set a standard for passing the field test Our standard is set at 25 hits You must hit the ball against the front wall at least 25 times in a trial. This meets the “standard” for entry into intermediate racquetball Recall a trial consists of the total of two attempts You want to see if players can achieve the standard on each trial. If you determine the consistency of their meeting the standard, this is a criterion-referenced reliability study. Reliability study

22 Failed to meet standard (<25) Met the standard (>=25) Failed to meet standard (< 25) Met the standard (>= 25)

23 Chi square = 23.6, p <.001 Phi = 0.65 Percent agreement = (37 + 11)/56 = 48/56 = 85.7% SPSS output This field test demonstrates acceptable criterion-referenced reliability

24 The standard for passing the field test is 25 hits We need a criterion measure of TRUE racquetball ability We used self reported racquetball experience Inexperience = novice player Experienced = skilled OR completed beginning racquetball class You want to see if experienced players are more likely to achieve the standard on the field test and the inexperienced players are less likely to meet the field test standard. This is a criterion-referenced validity study. Validity study

25 Inexperienced Experienced < 25 hits >= 25 hits

26 SPSS output Trial 1 vs. Criterion Chi square = 6.7, p <.01 Phi = 0.35 Percent agreement = (33 + 8)/56 = 41/56 = 73%

27 SPSS output Trial 2 vs. Criterion Chi square = 4.8, p <.03 Phi = 0.29 Percent agreement = (30 + 9)/56 = 39/56 = 70% The results of the TWO validity studies suggest this field test and the criterion of 25 hits is a moderately valid measure of racquetball experience

28 Table 7-8 Research Designs in Epidemiology Longitudinal, generally long term tracking of populationsCohort Known cases of mortality or morbidity are compared to matched non cases Case-control Compare results of a study group to the populationProportionate mortality or morbidity study A snapshot of identifiable groups at one point in timeCross-sectional Noting cases at a particular time or placeCases series Observational Randomly assign whole communities to treatments or exposures Community trial Randomly assign subjects to treatments or exposuresRandomized clinical trial Experimental DescriptionType

29 Epidemiological statistics Incidence – the number, proportion, rate, or percentage of new cases of mortality and morbidity. Incidence could be calculated in a randomized clinical trial or a prospective, longitudinal cohort study. Prevalence – the number, proportion, rate, or percentage of total cases of mortality and morbidity. Prevalence would be calculated in a cross-sectional study.

30 Estimates of Risk Absolute risk - the risk (proportion, percentage, rate) of mortality or morbidity in a population that is exposed or not exposed to a risk factor. Relative risk - the ratio of risks between the exposed or unexposed populations. This statistic is calculated with incidence measures. Odds ratio - an estimate of relative risk used in prevalence studies. Attributable risk - the risk of mortality and morbidity directly related to a risk factor. It can be thought of as the reduction in risk related to removing a risk factor.

31 Table 7-9 Results of a hypothetical study relating cholesterol and heart attack mortality D 37 C7C7 No High Cholesterol B 31 A 25 High Cholesterol No Heart Attack Deaths Heart Attack Deaths Outcome Exposure


Download ppt "Chapter 7 Criterion-Referenced Measurement PoorSufficientBetter."

Similar presentations


Ads by Google